Power Supply - IMG STAGELINE MINICUBE-60 Mode D'emploi

•
For cleaning the housing, only use a dry,
soft cloth; never use water or chemicals . For
cleaning the plastic lenses of the LEDs, a mild
detergent may be used . Always disconnect
the mains plug before cleaning .
•
No guarantee claims for the unit and no li-
ability for any resulting personal damage or
material damage will be accepted if the unit
is used for other purposes than originally
intended, if it is not safely installed or not
correctly connected or operated, or if it is not
repaired in an expert way .
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harm-
ful to the environment .
3 Applications and Setting Up
The moving head is used for effect illumination,
e . g . on stage and in clubs . It is equipped with
six powerful 10 W RGBW LEDs and, as the most
striking feature, with RGB LED strips on the 12
edges of the cube . The MINICUBE-60 is designed
for operation via a DMX light controller, but it
is also suited for independent operation . In this
mode, various automatic or music-controlled
light show programs are available .
Set up the unit on a solid, flat surface .
Alternatively, install it upside down on a lighting
stand system . For this, two sturdy mounting
clamps are required . Fasten the clamps on the
mounting brackets provided . Insert the bolts
into the holes (4) provided on the lower side of
the unit and turn clockwise to the stop . Screw
the clamps, together with the unit, onto the
lighting stand system .
Always keep a minimum distance of 50 cm
to the illuminated surface .

4 Power Supply

Important! For power supply, the MINICUBE-60
is equipped with Powercon connectors . Never
connect or disconnect a Powercon plug while
voltage is applied . Always make the Powercon
connection before connecting the unit to the
mains socket . After operation, disconnect the
unit from the mains socket before disconnecting
the Powercon connection .
1) Via the mains jack "230 V~ / 50 Hz" (9), con-
nect the moving head to a mains socket
(230 V/ 50 Hz) using the mains cable provided .
Insert the blue Powercon plug of the mains
cable into the mains jack . Turn the plug clock-
wise until it engages . To remove the plug, pull
back the safety latch of the plug and turn the
plug counter-clockwise .
2) If multiple MINICUBE-60 are used, connect
the white jack POWER OUT (7) of the first
unit to the mains jack "230 V~ / 50 Hz" of
the second unit . For this, a mains cable with
Powercon plugs (NAC-3FCB and NAC-3FCA)
is required . Then connect the second unit to
the third unit etc . until all units have been
connected in a chain . Thus, up to 20 units
can be interconnected .
3) The jack POWER OUT (7) can also be used
for supply power of other (light effect)
units . However, the current load of the jacks
"230 V~ / 50 Hz" and POWER OUT must not
exceed 16 A: Risk of short and fire due to
overload!
As soon as the moving head is supplied with
power, it will start and go to the last operating
mode selected .
WARNING To prevent damage to your eyes,
never look directly into the LEDs .
Please note that fast changes in
lighting may trigger epileptic sei-
zures with photosensitive persons
or persons with epilepsy!
9