Setting The Start Address And The Number Of Dmx Channels - IMG STAGELINE MINICUBE-60 Mode D'emploi

6.2 Setting the start address and
the number of DMX channels
For separate control of all DMX units connected
to the light controller, each unit must have its
own start address . Example: If the first DMX
channel of the MINICUBE-60 is to be controlled
by the light controller via DMX address 6, set
the start address on the MINICUBE-60 to 6 . All
other DMX channels of the MINICUBE-60 will
be automatically assigned to the subsequent
addresses .
Examples with different start addresses:
Number Start
of DMX address
channels MINICUBE-60
1
8
6
1
23
24
1
27
486
1
69
444
1) Press the button MENU once: The display will
show
DMX Address
2) Press the button ENTER . The address starts
flashing . Use the button UP or DOWN to set
the start address within 8 seconds .
3) Press the button ENTER: The display will show
again .
DMX Address
4) Press the button MENU once: The display will
show
Channel Mode
5) Press the button ENTER . The number of DMX
channels starts flashing . Use the button UP or
DOWN to set the number within 8 seconds .
6) Press the button ENTER to save the setting .
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
Addresses Next possible start
used by address for the
following DMX unit
1 – 8 9
6 – 13 14
1 – 23 24
24 – 46 47
1 – 27 28
486 – 512 –
1 – 69 70
444 – 512 –
.
.
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®
7) Set the same start address and the same num-
ber of channels for all other MINICUBE-60 to
be controlled synchronously .
8) DMX control of the moving head will now be
possible . The DMX functions can be found
on pages 20 – 22 . If the moving head does
not receive any DMX control signal, it will go
to the independent mode (chapter 5) .
Hint: When two or more MINICUBE-60 are controlled
via the same start address, invert the direction of move-
ment on one or more moving heads (refer to page 3,
menu item "Pan Inverse") . Thus, when a pair of moving
heads is used, their rotating arms will move in opposite
directions (mirror-inverted movements) .
7 Specifications
Data protocol: . . . . . . . DMX 512
Number of
DMX channels: . . . . . . 69, 27, 23 or 8
Light source
6 × beam LED: . . . . . 10 W RGBW LED from
12 × LED strips: . . . . 6 × 5050SMD (RGB)
Pan / TIlt angle: . . . . . . . Pan 560°, Tilt ∞
Ventilation: . . . . . . . . . integrated fan
Ambient temperature: 0 – 40 °C
Power supply: . . . . . . . 230 V/ 50 Hz
Power consumption: . . 175 VA
Dimensions: . . . . . . . . 27 × 35 × 20 cm
Weight: . . . . . . . . . . . 6 kg
Connections
DMX: . . . . . . . . . . . XLR, 3 poles
Mains: . . . . . . . . . . . Powercon
Subject to technical modification .
OSRAM
beam angle: 10°
(1 × In, 1 × Out)
(1 × In, 1 × Out)
11