Safety Notes - IMG STAGELINE MINICUBE-60 Mode D'emploi

Compact LED Beam Moving Head
These instructions are intended for installers of
the unit and for users with basic knowledge in
DMX control . Please read the instructions care-
fully prior to operation and keep them for later
reference .
1 Overview
1 Rotating arm
2 Lower part, always hold the lower part when
carrying the unit
3 Control buttons MENU, UP, DOWN and ENTER
for the operating mode and for making set-
tings via the menu
4 Support for the mounting brackets provided
( chapter 3, second paragraph)
☞
5 DMX signal output (XLR, 3 poles) to connect
the DMX input of another DMX light effect
unit
6 DMX signal input (XLR, 3 poles) to connect a
DMX light controller or to connect the DMX
output of another DMX-controlled unit
7 Powercon mains jack POWER OUT for power
®
supply of another light effect unit
8 Support for the mains fuse
Always replace a blown fuse by one of the
same type!
9 Powercon mains jack for connection to a
socket (230 V/ 50 Hz) via the mains cable pro-
vided
8
MINICUBE-60
MINICUBE
-60
MENU UP DOWN ENTER
3
4
1
2
4

2 Safety Notes

The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit uses dangerous mains
•
The unit is suitable for indoor use only . Protect
it against dripping water, splash water and
high air humidity . The admissible ambient
temperature range is 0 – 40 °C .
•
The heat produced inside the unit must be
dissipated by air circulation; never cover the
air vents of the housing .
•
Immediately disconnect the mains plug from
the socket
1 . if the unit or the mains cable is visibly
damaged,
2 . if a defect might have occurred after the
unit was dropped or suffered a similar
accident,
3 . if malfunctions occur .
In any case, the unit must be repaired by
skilled personnel .
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug .
•
When carrying the unit, always hold the lower
part . Never carry the unit by the cube or by
the rotating arm (1)!
7
5
6
9
voltage . Leave servicing to skilled
personnel and do not insert any-
thing into the air vents . Inexpert
handling may result in electric
shock .
8
.