Nolan N40 Full Sécurité Et Instructions D'utilisation page 21

11. Side Plates Assembly
To assemble the side plates first remove the lateral latches and (if assembled) the
peak and the visor (see instructions above).
11.1. Place the left side plate on the corresponding side mechanism centring its hole
on the mechanism and its teeth (Fig. 16).
11.2. If you wish to assemble the peak above the plates see the relevant installation
instructions.
11.3. Assemble the left lateral latch as indicated in the instructions above.
11.4. Follow the same steps on the right side of the helmet.
12. Side Plates Disassembly
To disassemble the side plates first remove the lateral latches and (if assembled) the
peak (see instructions above).
Then remove the plates from the side mechanisms.
Next, reassemble the visor and then the peak (if any) as explained in the previous
instructions.
WARNING
- When using the helmet in a configuration without the visor, always assemble the
lateral latches and the side plates.
- Do not use the helmet if the plates and the lateral latches have not been assem-
bled properly.
- If the peak is assembled over the plates the proper operation as described
previously.
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please refer to a Nolan
authorized dealer.
VISION PROTECTION SYSTEM (VPS)
The exclusive inner VISION PROTECTION SYSTEM (VPS) is a LEXAN™
nate moulded sunscreen with scratch-resistant/fog-resistant treatment. Very simple
and practical to use. Just lower to activate it or lift to remove it from the field of vision.
It is useful in all sorts of situations, both on long journeys out of town and shorter
town trips.
Moreover, the innovative fastening system allows you to assemble and disassemble
the sunscreen without the need for any tools for ordinary maintenance and cleaning
operations.
VPS Operation
The VPS mechanism allows to activate the sunscreen by simply lowering it until it
partially covers the visor field of vision. In this way, the desired light transmittance
reduction is achieved. At any time, without operating the visor, the VPS can be deac-
tivated with a simple movement and easily lifted up to restore the normal conditions
of visibility and protection guaranteed by the approved helmet visor.
To deactivate the VPS, push the side slider completely downwards (Fig. 17 A).
To completely activate the VPS push the side slider completely upwards (Fig. 17 B).
(*) LEXAN is a trademark of SABIC.
21
(*) polycarbo-