Nolan N40 Full Sécurité Et Instructions D'utilisation page 19

WARNING
Every time you wish to release the chin guard to use your helmet in the jet configu-
ration, insert the right and left chin guard locking slot covers (chin guard covers) in
the slots on the right and left side frames and push them towards the inside of the
helmet until you hear a fastening click (Fig. 11).
NOTE: The left and right chin guard covers are different from each other and are mar-
ked on their back as "DX" (right) and "SX" (left).
8. Removable Protective Chin Guard Fastening
Before fastening the chin guard to the helmet, remove the chin guard covers by per-
forming the following operations:
8.1. Open the visor completely.
8.2. Remove the right and left chin guard covers by pulling them outwards (Fig. 11).
8.3. Insert the right and left chin guard ends simultaneously into the slots on the cor-
responding side frames of the helmet and press the chin guard towards the insi-
de of the helmet until you hear the fastening click on both sides (Fig. 12).
8.4. Make sure the chin guard is correctly fastened at both ends by gently pulling it
towards the outside of the helmet.
WARNING
- Never remove or disassemble the semi-rigid inner padding of the protective
chin guard.
- When the helmet is used without the removable protective chin guard, always
assemble the chin guard covers supplied.
- If in doubt on how the manual chin guard release device works, please contact
a Nolan dealer.
(Available as standard or accessory/spare part).
9. Inner Visor PINLOCK
9.1. Disassemble the visor (see instructions above).
9.2. Make sure that the inner surface of the visor is clean and check that the pin
adjustment external levers are turned inwards (Fig. 15).
9.3. Place the PINLOCK
WARNING: The silicone-sealed profile of the PINLOCK
contact with the inner surface of the visor.
9.4. Insert one side of the PINLOCK
in position (Fig. 13).
9.5. Widen the visor and fasten the other side of the PINLOCK
second pin (Fig. 14).
9.6. Release the visor.
9.7. Remove the protective film from the PINLOCK
entire silicone-sealed profile of the inner visor adheres to the visor.
9.8. Fit the visor on the helmet (see instructions above).
® Assembly
® inner visor on the visor.
® inner visor on one of the visor pins and hold it
19
® inner visor must be in
® inner visor to the
® inner visor and check that the