OPERATION
The LCD display shows you all informations about moving head control
The wheel is used to select all menus and validate your setups
MENU :
- DMX address : Used to select DMX address
- Display :
- Showreve : Select display : Normal or reversed ( 180° )
- Language : To select language ( chineese or english )
- Brigsett : To set the brightness of the display ( between 00 and 255 )
- Backlight : To set the delay of the backlight ( either 60s, either backlight light always )
- MenuBack : to select the delay to main menu return ( either after 60s, either never )
- Backflash : DMX display indication ( either display blink when no DMX signal, either no blick )
- : To return to previous menu
- Features :
- X / Y setup : Pan and Tilt setups
- Xreverse : Pan move ( normal or reversed )
- Yreverse : Tilt move ( normal or reversed )
- XY speed : Pan / tilt moves speed ( Fast, normal or slow )
- Angle Pan : 360°/ 540° / 630°
- XY Fback : Test Pan / Tilt
- : To return to previous menu
- Shortcut : shortcut colors and gobos ( whithout ( Off ) or with ( Open ))
- Fullcolor : Display color on color wheel ( half color ( Off ) or Full color ( Open ))
- Chanmode : DMX mode select ( soit simple ( small 16 CH or normal( standard 24CH))
- Recemode : Operating mode select( DMX, wireless or auto )
- Runmode : Stand alone mode select ( slave ( slve ), Sound ( Musc ) or auto ( Auto ))
- Sigclear : Input DMX signal select ( Keep input DMX signal ( Keep ) or clear input DMX signal ( clear ))
- DMX reset : DMX reset validate ( No DMX reset ( Off ) or DMX reset ( Open )
- : To return to previous menu
- Lampset : lamp setup
- Default : lamp default setup ( Loamp off ( Wink ), Lamp on ( ilum ))
- Control : Lamp state control ( Manual lamp off ( Wink ), Manual lamp on ( Ilum ))
- DMX lamp : DMX lamp control ( DMX lamp control disable ( Off ), DMX lamp control enable ( Open ))
- Lamptime : Lamp Used time
- Cleartim : Reset lamp used time ( Enter password ( ) then Ilum to reset )
- : To return to previous menu
© Copyright LOTRONIC 2015
HOTBEAM-10R
Page 6