Maintenance Of The Extractor; Remove The Inlet Grille; Replace Inlet Grille; Cleaning The Grease Filter - Novy Easy Recirculation 1861 Mode D'emploi

8.2 Maintenance of the extractor

8.2.1 Remove the inlet grille


Do not use any objects that could damage the
inlet grille, such as potscourers, scouring agents
or aggressive cleaning agents.

First switch off the hob and the delay before
removing components from the extractor.
– Press on the right of the inlet grille until it tilts.
– Grasp the inlet grille and put it aside safely on the kitchen
worktop.

Do not place the inlet grille on the hob glass to
avoid scratches. Do not place the inlet grille on
a hob that has been switched on to prevent it
heating up.

8.2.2 Replace inlet grille


Take care that the Monoblock fi lter and grease
fi lter have fi rst been placed in the appliance
before replacing the inlet grille.
– Grasp the inlet grille and insert it in the centre of the extraction
opening in line with the position marks.

8.2.3 Cleaning the grease filter

When the grease filters need to be cleaned, this is indicated by
the grease filter cleaning indicator (see 4.5.1)
– Remove the inlet grille (see 8.2.1)
– Grasp the grease filter by the grips and lift it out of the
extraction opening
Wash in the dishwasher or submerge in hot water with anti-
grease dishwashing liquid.

WARNING: If the instructions above are not
carried out, serious soiling can cause a fi re
hazard.
After cleaning:
– Using the grips, replace the grease filter in the right direction
in the extraction opening.
– Replace the inlet grille in the extraction opening
– Reset the grease filter indicator (see 6.1)

8.2.4 Replacing the Monoblock filter

– Remove the inlet grille (see 8.2.1)
– Remove the grease filter (see 8.2.3)
– Grasp the Monoblock filter, tilting it forwards.
– Fold both corners over and remove the Monoblock filter from
the extraction opening
After replacing:
– Fold back the corners of the new Monoblock filter and
replace it in the frame through the extraction opening
– Press the filter right up against the frame
– Using the grips, replace the grease filter in the right direction
in the extraction opening.
– Replace the inlet grille in the extraction opening
– Reset the recirculation indicator (see 6.2)
– 55 –