Functions And Features Of The Robot Vacuum Cleaner; Included Accessories; Preparing For Use; Insert The Side Brushes - Miele Scout RX1 Instructions D'utilisation

Functions and features of the
robot vacuum cleaner
The robot vacuum cleaner is suitable for
the daily cleaning of short pile area
rugs, installed carpeting and hard floor-
ing.
Please be sure to observe your floor-
ing manufacturer's cleaning and care
instructions.
The robot vacuum cleaner is fitted with
a camera and various sensors. During
operation, the room plan as well as the
items present in the room are recorded.
The robot vacuum cleaner uses this
data to create an efficient vacuuming
plan of the surfaces to be vacuumed,
which it can then vacuum au-
tonomously.

Included accessories

– Two side brushes
– Two replacement exhaust filters
– Remote control / two batteries
– Base station, including a cleaning
brush
– Power supply unit with connector
– Power cord with plug
– Magnetic strip

Preparing for use

Diagrams 1 - 13 for this section are
at the end of these operating instruc-
tions.
Insert the side brushes (Fig. 01)
 Place the robot vacuum cleaner up-
side down on a level, clean surface.
Do not lift the robot vacuum cleaner
by the area around the dust box as it
can come loose.
 Press the two side brushes supplied
firmly but carefully onto the pins pro-
vided. Ensure that they match up cor-
rectly with the L and R markings.
Remove the protective foil (Fig. 02)
 Remove the protective foil from the
base station and from the top of the
robot vacuum cleaner.
Place the batteries in the remote
control (Fig. 03)
 Remove the battery compartment
cover.
 Insert the two batteries supplied,
making sure the polarity is correct.
Switch on the robot vacuum
cleaner (Fig. 04)
 Press the ON switch on the side of
the robot vacuum cleaner.
The rechargeable battery status and the
Auto standard vacuuming mode indica-
tors will light up in the display.
After approx. 60 seconds the robot vac-
uum cleaner will switch into standby.
The battery status indicator will con-
tinue to light up.
The robot vacuum cleaner is reactivated
by pressing any button on the remote
control or one of the two sensors in the
robot vacuum cleaner display.
en
13