Sony DVCAM DSR-20 Mode D'emploi page 34

Recording
Duplicate
30 EN
Chapter 2 Recording and Playback
If you copy a source tape, using the DUP (duplicate) button on this VCR,
you can copy the time code recorded on the source tape as they are. You
can easily make a work tape having the same time codes as the source
tape.
The duplicate function on this VCR works only when using a source tape
recorded in DVCAM format and making DV connections.
1
Connect this VCR and the other (playback) VCR, using a DV cable
and select DV with INPUT SELECT on this VCR.
2
Locate the points where you want to start playback and recording.
3
Press STOP to stop the tape transport operation.
4
Press and hold the DUP button, and press the PLAY button.
The DUP indicator flashes and this VCR enters into recording standby
mode.
Notes
• If the other (playback) VCR has already started playback, the DUP
indicator lights and duplicate starts immediately.
• If the other (playback) VCR is in the playback pause mode, duplicate
starts immediately and this VCR continues to record a still picture
and a certain time code.
5
Press the play button on the other VCR to start playback.
The DUP indicator lights and duplicate starts.
To adjust the point where duplicate starts
In step 4 above, press and hold the DUP button instead of the PLAY
button, and press the PAUSE button. This VCR remains recording standby
mode until you press PAUSE again.
After the other VCR starts playback, press PAUSE button at the point
where you want to start duplicate.
To stop duplicate
Press STOP.