Assembly Instructions; Led Indicator; Operating Instructions - Schumacher Electric SC1299 Guide D'utilisation

9. ASSEMBLY INSTRUCTIONS

9.1 Remove all cord wraps and uncoil the cables prior to using the battery charger.

10. LED INDICATOR

Pulsing green LED: The charger is connected to AC power.
Solid green LED: The charger is charging the battery.
LED off: The battery is fully charged; the charger is in Maintain Mode.
Solid red LED: Clamps are reversed.
See Operating Instructions for a complete description of the charger modes.

11. OPERATING INSTRUCTIONS

IMPORTANT: Do not start the vehicle with the charger connected to the AC outlet,
or it may damage the charger and your vehicle.
NOTE: This charger is equipped with an auto-start feature. Current is supplied
to the battery clamps before a battery is connected, and the clamps may spark if
touched together.
CHARGING A BATTERY IN THE VEHICLE
1. Turn off all the vehicle's accessories.
2. Keep the hood open.
3. Clean the battery terminals.
4. Place the charger on a dry, non-flammable surface.
5. Connect the battery clamps to the quick-connect cable.
6. Lay the DC cable away from any fan blades, belts, pulleys and other moving parts.
7. Connect the battery, following the precautions listed in sections 6 and 7.
8. Connect the charger to a live grounded 120V AC outlet. The green LED will pulse.
9. The LED will change to solid green to indicate charging; the LED will turn off
when the battery is fully charged.
10. When charging is complete, disconnect the charger from the AC power,
remove the clamps from the vehicle's chassis, and then remove the clamp
from the battery terminal.
CHARGING A BATTERY OUTSIDE OF THE VEHICLE
1. Place battery in a well-ventilated area.
2. Clean the battery terminals.
3. Connect the battery clamps to the quick-connect cable.
4. Connect the battery, following the precautions listed in sections 6 and 7.
• 8 •