Assembly Instructions; Features; Voltage Selector Switch; Circuit Breaker - Schumacher Electric MC-1 Guide D'utilisation

9.

ASSEMBLY INSTRUCTIONS

9.1 Remove all cord wraps and uncoil the cables prior to using the battery charger.

10. FEATURES

2

VOLTAGE SELECTOR SWITCH

Use this switch to select the correct voltage of the battery you are charging
(6 or 12V).

CIRCUIT BREAKER

This charger is equipped with an internal self-resetting circuit breaker. The
breaker protects the charger from temporary overloads. In the event of
an overload, the breaker will trip open and after a short cooling off period,
will reset automatically. This process is known as cycling and can be
recognized by an audible clicking sound. If the circuit breaker is cycling, see
the TROUBLESHOOTING section.

11. OPERATING INSTRUCTIONS

IMPORTANT: Do not start the vehicle with the charger connected to the AC
outlet, or it may damage the charger and your vehicle.
CHARGING A BATTERY IN THE VEHICLE
1. Turn off all the vehicle's accessories.
2. Keep the hood open.
3. Clean the battery terminals.
4. Place the charger on a dry, non-flammable surface.
5. Lay the AC/DC cables away from any fan blades, belts, pulleys and
other moving parts.
6. Connect the battery, following the precautions listed in sections 6 and 7.
7. Connect the charger to an electrical outlet.
8. When charging is complete, disconnect the charger from the AC power,
remove the clamps from the vehicle's chassis, and then remove the clamp
from the battery terminal.
1
1. Ring connectors (quick-connect)
2. Battery clamps (quick-connect)
3. Voltage selector switch
3
• 8 •