Set Sleep Timer - Krüger & Matz KM1663.1 Mode D'emploi

Owner's manual
Select a preset sound effect
Please note, you cannot use different sound effects at the same time.
During play, press P-eQ button repeatedly to select:
FLAT / POP/ jAzz / ROCK / CLASSIC
SeT ALARM TIMeR
This unit can be used as an alarm clock (FM Radio).
Note: Make sure that you have set the time correctly.
1. In standby mode, press and hold TIMER button, until [TIMER SET] scrolls on the
display. The hour digits are displayed and begin to blink.
2. Press / button on the front panel or remote control to set hour, then press
TIMeR button again to confirm. The minutes digits are displayed and begin to
blink.
3. Press / button on the front panel or remote control to set minute. Press
TIMeR button to confirm.
4. Press VOL +/– button to adjust volume, then press TIMeR button to confirm. A
clock icon appears on the display.
Activate/deactivate alarm timer
In standby mode, press TIMeR button repeatedly to activate/deactivate timer.
• If timer is activated, the icon
• If timer is deactivated, the icon
Note:
• The alarm timer is not available when the source is set as "AUDIO IN/AUX IN".

SeT SLeeP TIMeR

This unit can switch to standby mode automatically after a set period.
• When the unit is turned on, press SLEEP button repeatedly to select a preset
period (in minutes).
• When the sleep timer is activated, SLEEP icon is displayed.
• To deactivate the sleep timer, press SLEEP button repeatedly until [oFF] (sleep
off) appears.
is displayed.
disappears on the display.
25