Installation Of Batteries - Krüger & Matz KM1663.1 Mode D'emploi

INSTALLATIoN oF BATTeRIeS

1. Unscrew the screw at the back of the remote control.
2. Remove the insulating mylar strip from the battery if
the battery is being used for the first time. It is located
at the bottom back side of the remote control.
3. Pull out the battery compartment with your fingernails.
4. Replace a new battery (size 2025) correctly and fully
insert the battery compartment back to the original
position.
Note:
• Remove the batteries if the remote control is not going to be used for an
extended period of time.
• To avoid possible failure, read the following instructions and handle the remote
control properly.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control, nor place it on wet surfaces.
• Do not place the remote control under the direct sunlight or near sources of
heat.
• Clean this remote control only with soft, slightly damp cloth.
Remote Control operation Range
1. Point the remote control towards the
remote sensor IR of the front of the
unit.
2. Make sure that there is no obstacle
between the infrared remote sensor
of the unit and remote control.
20
Owner's manual