Unfold Stroller; Assembly - Quinny Zapp 01274 Mode D'emploi

NOTE: If wheels begin to
squeak, spray lubricant to the
axles.
1
Install Rear Wheels
Insert the rear wheel axle
into the frame until you
hear a "click" (Figure 1).
Repeat for other rear
wheel. Pull to confirm it is
assembled securely.
2
Install Front Wheels
Position front wheel with
logo facing outward.
Insert front wheel into the
tube of the frame until you
hear "click" (Figure 2).
Repeat for other front
wheel. Pull to confirm it is
assembled securely.
3

Unfold Stroller

Gently lift the stroller by
the hinge points. The
frame will start to
unfold itself (Figure 3).
TM
1
2
3
Pull the fold assembly
(labeled 3) outward until
you hear a "click"
(Figure 3a).
Press release button 1
(Figure 3b). The button
will stay pressed by itself.
Press release button 2,
while at the same time
raising the upper section
of the stroller (Figure 3c).
Release button 2 and lift
up further until you hear a
"click."
Extend the handle crossbar
into the horizontal position
until you hear a "click"
(Figure 3d).
3

Assembly

3a
3b
3c
3d