Stihl FS 70 Notice D'emploi page 18

English
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
Mount only metal cutting attachments.
Check direction of rotation of cutting
attachment
1
2
The cutting edges of the grass cutting
blades (1) and (2) may point in either
direction – these cutting attachments
must be turned over regularly to reduce
one-sided wear.
Cutting edges of grass cutting blade (3)
must point clockwise.
WARNING
Direction of rotation is indicated by an
arrow on the inside of the deflector.
16
Place the cutting attachment (4) on
N
the thrust plate (5).
WARNING
Collar (see arrow) must engage the
cutting attachment's mounting hole.
3
Securing the cutting attachment
Fit the thrust washer (6) – convex
N
side must face up.
Fit the rider plate (7).
N
Block the shaft (8).
N
Screw the mounting nut (9) on to the
N
shaft counterclockwise and tighten
it down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
Remove the tool used to block the shaft.
Removing the Metal Cutting Attachment
9
7
Wear protective gloves to reduce the
6 risk of direct contact with the sharp
cutting edges.
4
8
N
5
N
N
NOTICE
WARNING
Block the shaft.
Unscrew the mounting nut
clockwise.
Remove cutting attachment and its
mounting hardware from the
gearbox – but do not remove the
thrust plate (5).
FS 70 R