switel DCT4073 Mode D'emploi page 92

5.7 Calling back missed calls
The telephone stores the last ten calls in a calls list.
, y or z
ƒ
5.8 Dialling phone numbers stored in the phone book
Phone numbers stored in the phone book (refer to Section 8.1) can be dialled quickly and
easily.
¤, y or z
ƒ
Phone book entries can be selected directly by opening the phone book and entering
the first letters of the entry required. Example: To access the number for Peter", for ex-
ample, press / once and use the y or z buttons, if necessary, to select the
stored entry.
5.9 Adjusting the receiver volume
The volume can be adjusted to one of five settings during a call.
y or z
5.10 Muting the microphone in the handset
—
The handset microphone can be switched on and off during a telephone call. This enables you
to confer with a third party, for example, without the caller being able to hear you. The handset
loudspeaker, however, remains on; i.e. you can still hear the caller.
5.11 Talk time display
A few seconds after a call has been taken, the phone number dialled or that of the caller disap-
pears from the display and is replaced by the duration of call (hh−mm−ss).
5.12 Key lock
3 sec *
*, *
Incoming calls can be taken as normal even when the key lock function is activated (also refer
to Section 7.4). The key lock function remains active after the call has been ended.
5.13 Temporary tone dialling
If you only operate the telephone using the Pulse dialling method, you can still make use of the
advantages of the Tone dialling method (e.g.: for remote access of the answering machine).
*
When the call is ended, the telephone automatically switches back to Pulse dialling.
5.14 Notes on range
The handset has a range of approx. 50 meters in closed rooms and approx. 300 meters outdoors.
In the case of a good connection to the base station, the h icon lights up continuously in the dis-
play.
If the handset is moved too far from the base station, the h icon flashes and acoustic
warning signals are issued. Move towards the base station, otherwise the call will be di-
sconnected.
If the connection to the handset has been lost, the message BASE 1" appears in the
display.
5.15 Searching for the handset (Paging)
If you have misplaced the handset, it can be located easily. Press the Paging button on the base
station; the handset rings for 30 seconds. To terminate the ringing function before the 30 seconds
has elapsed, simply press the Paging button again or the Call button on the handset.
‘
‘ or ƒ
5.16 Switching the handset on /off
3 sec R
It is not possible to switch the handset on/off if the handset is in the base station.
92
− Telephoning −
Open and scroll through the entries stored
Dial the number
Open the phone book and select the phone book entry
Dial the number
Press the button during the call
Switch the function on/off
Activate the key lock function
Deactivate the key lock function
Switch to Tone dialling (for the duration of the call)
All the handsets registered on the base station ring.
Ends paging prematurely.
Switch on/off