Optional Accessories - CAB DUMPER 7 Manuel D'installation Et D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

With Dip 2 OFF = auto close disabled, the open, close and stop commands are sent with the remote control or button.

With the door closed, hold down MEMO RX and press the desired transmitter button within 5 sec.; the courtesy lamp will

flash to confirm memorization.

Repeat for each separate transmitter. Up to 20 different codes can be stored in this way.

TO DELETE A TRANSMITTER: hold down MEMO RX until the courtesy light turns on, then press the transmitter button;

the courtesy light flashes 3 times to confirm the deletion - now release the MEMO RX button.

RESETTING MEMORY: resets memory by deleting all memorized codes - hold down MEMO RX until the courtesy light

goes out

- the courtesy light flashes 9 times to confirm that the memory has been reset - now release the MEMO RX button.

COURTESY LIGHT SIGNALS

no FLASH = transmitter to memorize.

1 FLASH = transmitter memorized.

2 FLASHES = a previously memorized transmitter is being re-memorized.

3 FLASHES = a transmitter has been deleted.

4 FLASHES = in delete mode, transmitter not memorized.

5 FLASHES = memory full.

9 FLASHES = all memorized codes deleted.

Tilt-up doors

The DUMPER automation can also be installed to tilt-up doors; in this case you must install the AU.C25 adapter to the

door as shown in figure 17.

In order to join the bent arm of the DUMPER to the straight arm provided with the accessory AU.25 it is necessary to cut

the bent drive as shown in picture number 17 and using the straight arm as template, drill 2 holes of 6 mm of diameter and

so join the 2 arms (the screws are not provided).

Emergency battery kit

An emergency battery kit is available (code DM.BT) to allow the automation to work even during mains power failures.

Fit the batteries in their compartments and hook them up as shown in Figure 18.

TECHNICAL DATA

Power

Motor feed

Power draw

Standby power draw

Traction/thrust

Maximum stroke

Accessory power

Opening speed

Closing speed

Maximum load

Intermittency

Operating temperature

Protection rating

Noise level

Weight

MEMORIZING TRANSMITTERS