Skil AG2907-00 Guide D'utilisation page 15

d. While pressing the spindle lock, tighten
the lock nut by turning it clockwise with the
wrench supplied (Fig. 5).
To remove the grinding wheel:
a. Remove the battery pack from the tool.
b. While pressing the spindle lock, loosen the
lock nut by turning it counter-clockwise with
the wrench supplied.
WARNING
at a standstill.
WARNING
grinding wheel from the tool, or first allow
the grinding wheel to cool down. It may be
hot after prolonged use.
Installing the Auxiliary Handle
(Fig. 6)
The auxiliary handle, used to guide and
balance the tool, can be threaded into the front
housing on either side of the tool, depending on
personal preference and comfort.
Turn the tool OFF and remove the battery pack
before performing any assembly. Thread the
auxiliary handle into the desired position and
securely tighten it in place.
Press the spindle lock
only when the spindle is
Use protective gloves
when removing the
Fig. 5
Fig. 6
15