Chicco Balloon Mode D'emploi page 17

REMOVABLE ELECTRONIC TOY PANEL
be The toy bar is fitted with a sounds and lights panel that is activated by
hed pressing the buttons on the front section (Fig. F).
Fig. F1 : On button - volume
F2 : It plays soothing and relaxing tunes
in F3 : It plays lullabies
ght F4 : It plays funny music
F5 : Voice recording button
ide F6 : Sound and music activation handle
ety F7 : Microphone – LED
For the voice recording activation, check that the electronic toy is on.
Keep the button pressed F5; as soon as the red LED flashes, your voice
can be recorded, to stop recording release the button (the LED will turn
as off). The recording can have a maximum duration of 30 seconds.
he To listen to the recording, press the button.
ety To record again, repeat the steps described above.
ead To obtain an optimal recording, it is recommended to keep a distance
ree from the microphone (F7) of about 20 cm with a clear and decisive tone
he of voice; it is important not to block the microphone hole so as not to
compromise the quality of your recording.
The toy panel can be removed by pressing the button E1 (Fig. 18).
Once removed, the toy panel can be fixed to cot frames using the strap
the I1 (Fig. 19). The strap has two slots to make it compatible with most
cot frames (Fig.20).
ned WARNING: To prevent possible injury by entanglement, remove this
es, toy when the child starts trying to get up on its hands and knees in a
on crawling position.
The fixing strap (I1), when not in use, can be fixed back to the transport
the belt, as shown in Fig. 21
To refit the removable toy panel on the bar, slide it as indicated in Fig.
22 until you hear it "CLICK" into place.
ent VIBRATION UNIT
ent The vibration unit Fig. 23 is located on the front seat support.
the Turning the knob clockwise, the vibration starts, to turn it off, bring the
and knob back to "0".
nit
at- HOW TO REMOVE THE FABRIC COVER
It is possible to remove the seat cover and the booster cushion from the
reclined cradle to wash them.
ype 13. Remove the booster cushion.
AA 14. Remove the safety harness from the slots in the fabric and start to
remove the cover Fig.24. Release the 6 click buttons (Q) at the side
on. under the metal tubes, remove the cover on the vibration unit (Fig.
25), then take off the fabric through the entire frame paying atten-
tion not to damage it. To refit the cover, proceed in reverse order,
making sure that the lower fabric strap goes through the adjust-
any ment joints of the backrest (Fig. 26) and the toy bar support.
ong
This product complies with the Directive 2012/19/EU.
dis- The crossed bin symbol on the appliance indicates that the
product, at the end of its life, must be disposed of separately
the from domestic waste, either by taking it to a separate waste
disposal site for electric and electronic appliances or by re-
ing turning it to your dealer when you buy another similar appliance. The
s if user is responsible for taking the appliance to a special waste disposal
site at the end of its life. If the disused appliance is collected correctly
rns as separate waste, it can be recycled, treated and disposed of eco-
logically; this avoids a negative impact on both the environment and
may health, and contributes towards the recycling of the product's materi-
als. For further information regarding the waste disposal services avail-
may able, contact your local waste disposal agency or the shop where you
bought the appliance.
re-
ec-
on.
17