Publicité
Les langues disponibles
Les langues disponibles
All operating elements and connections described
can be found on the fold-out page 3.
1 Operating Elements
1.1 Fig. 1: Hand-held microphone
1 Microphone cartridge; to insert batteries, unscrew
the cartridge (figs. 2 to 4)
2 LC display; indicates the transmitting frequency
and the charging status of the batteries during op -
eration
3 Cap for the control part; remove the cap for opera-
tion (fig. 5)
4 Power switch
1.2 Figs. 2 to 4: Inserting batteries
(microphone cartridge unscrewed)
5 4-pole contact, each on the microphone cartridge
(fig. 2) and on the handle (fig. 3);
prior to assembling microphone cartridge and
handle, fit the contacts together
6 Lock for the battery holder (7);
to unlock the holder, press the lock in arrow direc-
tion backwards
7 Battery holder for two 1.5 V batteries of size AA (R6)
1.3 Fig. 5: Control part (cap removed)
8 Key SET
with the unit not locked:
for recalling and exiting the adjusting modes for
frequency/sensitivity/lock function → chapters
5.1, 5.2, and 5.3.1
with the unit locked:
for recalling and exiting the adjusting mode for
the lock function → chapter 5.3.2
9 Key
for reducing the frequency (in the frequency
adjusting mode) or the sensitivity (in the sensitivity
adjusting mode) and for deactivating the lock func-
tion (in the lock mode)
10 Key
for increasing the frequency (in the fre-
quency adjusting mode) or the sensitivity (in the
sensitivity adjusting mode) and for activating the
lock function (in the lock mode)
2 Important Notes
The unit corresponds to all relevant directives of the
EU and is therefore marked with
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient temperature
range 0 – 40 °C).
G
For cleaning only use a dry, soft cloth, by no means
chemicals or water.
G
No guarantee claims for the unit and no liability for
any resulting personal damage or material damage
will be accepted if the unit is used for other purposes
than originally intended, if it is not correctly operated
or not repaired in an expert way.
If the unit is to be put out of operation defini -
tively, take it to a local recycling plant for a
disposal which is not harmful to the environ-
ment.
Do not put exhausted batteries/defective recharge -
able batteries into the household rubbish but take
them to a special waste disposal (e. g. collective con-
tainer at your retailer).
3 Applications
In combination with the multifrequency receiver
US-9001D / 5 from JTS this dynamic hand-held micro-
phone with integrated multifrequency transmitter
makes up a wireless audio transmission system. With -
in the UHF frequency range of 518 – 542 MHz, the
transmitting frequency can be selected as desired (fre-
quency spacing 125 kHz).
The microphone is supplied with a stable transport
box, a microphone holder, and several plastic push-on
caps of different colours.
3.1 Conformity and
approval of the wireless microphone
Herewith, MONACOR INTERNATIONAL declare that
the unit MH-950 / 5 is in accordance with the basic
requirements and the other relevant regulations of the
directive 1999 / 5 / EC. The declaration of conformity
can be found in the Internet via the JTS home page
(www.jts-germany.de).
This unit may be operated in the following countries:
DE
In the Federal Republic of Germany, the unit requires
a frequency assignment (for which a fee is charged).
In other countries, it is necessary to apply for a corre-
sponding approval. Prior to operating the unit outside
Germany, please contact the MONACOR subsidiary
or the corresponding authorities of the respective
.
7
Publicité
