SIP STAR 850/26 T Mode D'emploi page 110

–
When preparing the machine for
transport or working position nobody is
allowed to stay in the area of moving
rotors.
–
Assure the transport position with
locked stop of the rotor holder.
–
When preparing the machine for
transport or working position, or in
transport position never switch on the
P.T.O. shaft! Material damage and
danger of dropping parts!
–
Be careful when driving the swather in
transport position in inclination as well
as driving in curves because of danger
of overthrowing.
–
Always place the declinatory tube of the
rotors into transport or working
position. Danger of stitch and material
damage!
18
19
20
21
2
22
B
Preparing the swather for high transport position
–
Lift the rotors with oneway-working cylinder
hydraulics;
–
Pull the string to lift the the stop of the rotor holder
and continue until the stop (1) is locked in transport
position (1), release the pressure in the hydraulic
system;
–
Switch on the twoway-working cylinder hydraulics
to lower the rotors to the holder's restriction;
–
Set the declinatory tube (3) into inclined position
(A).
17
STAR
1
A
3