patura P 4500 Notice D'emploi page 64

Montageanleitung / Instructions de montage
Installation Instructions / Montagehandleiding
Indicaciones de montaje
Changing the Address setting
You may want to change the address setting of your energiser:
·
If you are using more than one remote-controlled energiser on your property and you want
each remote control handset to operate one energiser only or in reverse when you want one
remote control handset to operate more than one energiser.
·
If an adjacent property has an energiser that is operating at the same address setting.
·
If your energiser turns off unexpectedly quite often.
Different address settings for each energiser prevents unintentional activation or deactivation of
fence lines. The address setting of new energisers is 1 (one).
Changing the address setting of the remote control handset:
Note: The remote control feature can only be changed during the first 10 minutes of operation
1. Move the switch of the energiser to
Wait 5 seconds, and switch it back on to the desired position.
2. Press to turn on the remote control handset.
3. Hold the remote control handset within 5 to15 cm of the energiser and press
The energiser will stop pulsing and the word "OFF" will appear in the top part of the display.
4. Press to turn off the remote control handset.
5. Press and hold
The remote control handset is now in the address setting mode.
6. Press repeatedly until "AD" is shown on the display.
7. Press and hold
(addresses from 1 to 15 are available).
8. Hold the remote control handset within 5 to 15 cm of the energiser and press
To transmit the new setting to the energiser. The new address setting will appear for
2 seconds in the display.
9. Once the energiser's remote control feature has been activated, you will not need to perform
the activation procedure again..
64
.
and then press to turn on the remote control handset.
until the address setting you want is displayed.
.
.