Using A Remote Control Handset - patura P 4500 Notice D'emploi

Montageanleitung / Instructions de montage
Installation Instructions / Montagehandleiding
Indicaciones de montaje
Regular recharging of the battery is essential. Use a suitable safety approved battery charger and
refer to the battery manufacturer's recommendations.
1. Disconnect the battery from the energiser.
2. Attach the positive (+) battery charger lead to the positive terminal of the battery, and the
negative (–) battery charger lead to the negative terminal on the battery.
3. Connect the battery charger's input power plug to a mains or line socket and turn on the
power supply.
4. After the battery is charged, disconnect it from the battery charger before connecting it to
the energiser.
Caution! Over-charging the battery will reduce its life. Do not exceed the recommendations of the
battery manufacturer on recharging the battery from a mains-powered (line-powered) source.
Battery care and maintenance
·
House the battery in a suitably designed battery box, if the battery is likely to be exposed to the
weather.
·
When not in use, keep the battery as fully charged as possible.
·
Recharge a discharged battery as soon as possible.
·
Batteries should be stored fully charged and recharged at regular intervals (every 8 weeks)
·
Inspect the battery regularly to ensure that the electrolyte level does not fall below 12 mm (½")
above the surface of the battery plates (observe check marks).
·
Inspect the battery regularly to ensure that the electrolyte level does not fall below 12 mm (½")
above the surface of the battery plates (observe check marks).
Battery safety
• Ensure that the battery is well ventilated when recharging.
• Avoid temperatures greater than 50 °C (120 °F).
• Ensure the battery is not exposed to naked flame or sparks.
Using a remote control handset (P4600 and P6000 only)
Note: The P4500 energiser cannot be used with a remote control handset.
The P4600/P6000 will accept commands from a remote control handset. No configuration is
required. The energiser and remote control are pre-programmed to communicate.
The remote control handset with Fence compass is three tools in one. It acts as a
·
Remote control – Switching the energiser on or off from any location on the electric fence system
·
Voltmeter/Ammeter – Providing instant feedback on fence performance (voltage and current)
·
Fault finder – Assisting in the location of faults anywhere on the fence system
For detailed instructions on using the remote control handset, refer to the user manual supplied
with the handset.
62