Getting Started; Charging The Battery - Kokido Vektro Auto RC30 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GETTING STARTED

Charging The Battery

IMPORTANT NOTE: Fully charge the robot (about 5-6 hrs) before using it for the first
time.
WARNING!
 Use only the original external adaptor and charging cable provided.
 Make sure the robot and the charger port are clean and dry before set-up.
 Make sure that the robot is turned off by sliding the switch to OFF position prior to
charging.
1. Place the unit on a flat surface. Sliding the switch to the OFF position.
2. Connect the adaptor cable to the charging cable. Align and insert the plug of charging
cable into the charging port on the top of the unit.
3. Connect the external adaptor to the power source. Once the robot begins charging,
the indicator light on the external adaptor will turn red. Normally, it takes about 4.5-5
hours to reach a full charge. The indicator light will turn green when the robot is
almost fully charged.
Immediately disconnect the external adaptor from the power source if you detect any
of the following conditions:
-
Offensive or unusual odor
-
Excessive heat
-
Deformation, cracks, leaks
-
Smoke
4. When charging is complete, disconnect the external adaptor from the power source
and unplug the charging cable from the unit and external adaptor.
Normally the robot can be operated up to 90 minutes on a full charge.
Note: Clean the debris compartment regularly. Excessive debris inside the debris
compartment will increase the burden to the motor operation and shorten the operating
duration as a result.
NOTE: Rechargeable lithium-ion battery is classified as a consumable item. It has a
limited life and will gradually lose its capacity to hold a charge. Therefore, the running
time of the robot will gradually reduce after repeated charging and discharging
throughout its product life.
8

Publicité

Table des Matières
loading

Table des Matières