Kokido Vektro Auto RC30 Manuel D'utilisation page 12

2. Hold the handle of swivel head and move the robot to the water surface and slide the
switch to ON position. Power indicator light will turn on.
3. Immerse the robot into the water. Robot will start the operation automatically as soon
as the water covers the water sensors on top of swivel head. Let the robot sink to the pool
floor. Orient the robot with its front/back facing the pool wall with help of the rope.
Observe the cleaner's first forward and reversed movements over the pool bottom. If the
robot runs along the pool wall instead of running perpendicular to it, reposition it making
sure that its front/back faces the pool wall.
Power indicator light starts to blink when remaining power is down to 10 minutes.
Power indicator light :
No light - Power off / no power
Light - Power on
Blinking light - Battery power will be exhausted within 10 minutes.
NOTE:
- Never attempt to make contact with both water sensors with anything other than water.
4. To retrieve the robot from the pool, catch the float and pull the rope to retrieve the
robot. If float is so far to be caught by hand, use the hook provided. Place the hook on
the telescopic pole (not provided) and then use the hook to catch the float. Once robot
is coming to water surface, catch and hold the grip located at the end of cleaner's
bottom (underneath "orange triangle pattern") and lift the cleaner to drain out the
water from the robot.
11