Hilti PD-I Mode D'emploi page 14

2. Aim the tool at the next target point and press the "Measure" button.
◁ The target distance is calculated immediately and shown in the result line.
5.15.4 Indirect vertical distance II (2 angles, 1 distance)
1. Aim the tool at the target point and press the "Measure" button.
◁ The first distance and angle are measured and shown in the intermediate result line.
◁ The graphical display automatically prompts you to measure the second distance.
2. Aim the tool at the next target point and press the "Measure" button.
◁ The target distance is calculated immediately and shown in the result line.
6 Care, transport and storage
6.1 Cleaning
▶ Do not touch the lens with the fingers.
▶ Clean the lens by blowing the dust off or by wiping with a clean, dry cloth.
▶ Do not use liquids other than pure alcohol or water.
6.2 Transport
Note
The batteries must be insulated or removed from the product before it is shipped or sent by mail.
▶ Use the Hilti packaging or packaging of equivalent quality for transporting or shipping your equipment.
6.3 Storage and drying
▶ Do not put the product into storage when wet. Allow it to dry before putting it away.
▶ Observe the temperature limits given in the Technical Data section which are applicable to storage or
transport of the equipment.
▶ Check the accuracy of the equipment before it is used after a long period of storage or transportation.
6.4 Disposal
WARNING
Risk of injury. Hazards presented by improper disposal.
▶ Improper disposal of the equipment may have the following consequences: The burning of plastic
components generates toxic fumes which may present a health hazard. Batteries may explode
if damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or
environmental pollution. Careless disposal may permit unauthorized and improper use of the
equipment. This may result in serious personal injury, injury to third parties and pollution of the
environment.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information.
In accordance with the European Directive on waste electrical and electronic equipment and its implemen-
tation in conformance with national law, electric tools or appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
▶ Disposal of electric tools or appliances together with household waste is not permissible.
7 FCC statement / IC statement
CAUTION This product has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. These products generate, use and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause interference
to radio communications.
10