Hilti PD-I Mode D'emploi page 12

5.11 Special functions
5.11.1 Automatic brightness sensor
▶ Select the symbol for the automatic brightness sensor from the special functions menu.
Note
The automatic brightness sensor automatically dims the lighting on the display in dark surroundings.
This saves battery power.
5.11.2 Min/max delta function
1. Select the symbol for the min/max delta function from the special functions menu.
2. Aim the tool at the target point and press the "Measure" button.
3. Press the "Measure" button to stop measuring.
◁ The last distances measured are shown in the results line.
5.11.3 Painter's area
1. Aim the tool at the target point for the first room length and press the "Measure" button.
◁ The result is saved as an intermediate result.
2. Aim the tool at the target for the next room length and press the "Measure" button to take the
measurement.
◁ The second result is shown in the intermediate results table. The intermediate result shown in bold is
the sum of the measured room lengths.
3. Repeat this procedure until all room lengths have been measured.
4. Press the right arrow button to switch to room height and confirm by pressing the "Measure" button.
5. Position and aim the tool for room height measurement and then take the measurement.
◁ The room height is measured and displayed in the intermediate result line. The painter's area is
calculated immediately and shown in the result line.
5.11.4 Timer
1. Select the timer symbol from the special functions menu.
2. Set the timer to 2, 5 or 10 seconds and confirm by pressing the "Measure" button.
3. Select the "Measure" symbol to trigger the delayed measurement.
5.11.5 Data memory
1. Select the data storage symbol from the special functions menu.
Note
The tool can save up to 30 screens, including the graphical symbols. If 30 screens have already
been saved, the oldest one will be deleted automatically when a new screen is saved.
2. To delete data storage memory, press and hold the C-button for 2 seconds while the data storage screen
is displayed.
5.12 Trapezoid
5.12.1 Trapezoid function (3 distances)
1. Select the symbol for the trapezoid function for 3 distances from the trapezoid functions menu.
2. Aim the tool at the target point and press the "Measure" button.
◁ After measuring the first distance, the graphical display automatically prompts you to take the next
measurement.
3. Aim the tool at the next target point and press the "Measure" button.
4. Aim the tool at the third target point and press the "Measure" button.
5.12.2 Trapezoid with Inclination (2 distances, 1 angle)
1. Select the symbol for the trapezoid function with inclination from the trapezoid functions menu.
2. Aim the tool at the target point and press the "Measure" button.
3. Aim the tool at the next target point and press the "Measure" button.
8