Publicité
EN
1) GENERAL FITTING INSTRUCTIONS
Before the preparation of the vehicle chassis and installation
of the Hydraulic Tail Lift (= named HTL hereafter), read and
make sure you understand the underlying fitting instructions
first, and progress step by step after that.
Before getting started, also take notice of the safety
instructions for repair and maintenance, included
in the user's manual issued with this HTL. In case
of doubt, and before making any further progress,
please consult your Dhollandia-agent.
After installation, perform the put-into-service test following
the check-list included in the user's manual, and fill-out the
CE Fitting Declaration in the same document.
Check the following points before getting started:
•
Check if the kit is complete, and if all parts needed to fit the
HTL correctly have been delivered.
•
Compare the voltage of the batteries of the vehicle with the
voltage of the hydraulic power pack of the HTL.
•
Compare the fitting dimensions given on the "FITTING
DRAWING" [see Fig. 1.1] with the actual dimensions of the
vehicle concerned . The actual floor height K should not
exceed the theoretical maximum lifting height of the HTL,
which depends on its arm-length.
•
Observe the FITTING AND BODY BUILDING
INSTRUCTIONS of the manufacturer of the vehi-
cle. Observe in particular the maximum allowed
HTL capacity, the instructions on the use of hy-
draulic stabilising legs, the instructions for
mounting and bolting to the vehicle chassis, and
the manufacturer's guidelines for the electrical
interfaces. [See Fig. 1.2]
DHOLLANDIA
1.1
EX.
1.2
5
Publicité
