Reducing Video Noise; Setting Child Lock; Selecting A Decoder Input Terminal - Pioneer PDP-LX608D Mode D'emploi

08 Setting up
11 Select "Colour System" (/).
12 Select a colour system (/).
You can select from among "Auto", "PAL", "SECAM", and "4.43NTSC".
13 Select "Store" (/).
14 Select "Yes", "Yes (Listed)", or "No" (/).
Item Description
Yes You can select the channel using P+/P–
Yes (Listed)
Select this option to register the channel as your
favourite channel.
You can select the channel using the Favourite
Channel list and P+/P–.
No You cannot select the channel using P+/P–
15 Press HOME MENU to exit the menu.
• Alternatively, to set up for another channel, repeat steps 6 to 14.
Note
• The above procedure transfers and sets the selected channel
information to the connected recording equipment such as a
VCR or DVD/HDD recorder (DVR).
• Manual Adjust also allows you to make selections for "Tuner
NR", "Child Lock", and "Decoder". See Reducing video noise,
Setting Child Lock, and Selecting a decoder input terminal.

Reducing video noise

For the individual channels, you can specify whether the plasma
television should reduce video noise depending on the levels of
broadcasting signals.
1 Press HOME MENU.
2 Select "Setup" (/ then ENTER).
3 Select "Analogue TV Setup" (/ then ENTER).
The password entry screen appears. Enter your four-digit password
using buttons 0 to 9. For the password, see Using a password on
page 56.
4 Select "Manual Adjust" (/ then ENTER).
5 Select "Programme Entry" (/).
6 Select a programme number (/).
You can select 1 through 99.
7 Select "Tuner NR" (/).
8 Select "On" (/).
9 Press HOME MENU to exit the menu.
Note
• This function may not achieve a satisfactory result, depending on
the conditions of broadcasting signals.
• When using a decoder with a decoder terminal selected, this
function may fail to achieve a good result.
• The factory default is "On".
28
En

Setting Child Lock

Child Lock inhibits selected TV channels from being tuned and
watched.
1 Repeat steps 1 to 6 provided for Reducing video noise.
After selecting a channel (using Programme Entry), perform the
following steps:
2 Select "Child Lock" (/).
3 Select "Block" (/).
• The selection is switched between "View" (factory default) and
"Block".
4 Press HOME MENU to exit the menu.

Selecting a decoder input terminal

If you have connected a decoder, select a decoder input terminal
(INPUT 1).
1 Repeat steps 1 to 6 provided for Reducing video noise.
After selecting a channel (using Programme Entry), perform the
following steps:
2 Select "Decoder" (/).
3 Select "INPUT 1" (/).
4 Press HOME MENU to exit the menu.
Note
• With "Off" (factory default) selected, you cannot watch any
images from the decoder.
• While watching DTV, no image is output to the decoder.