Reconfiguring The Dtv Channel Settings - Pioneer PDP-LX608D Mode D'emploi

09 Enjoying DTV broadcasts
Viewing subtitles
When in the DTV mode, press [ to turn subtitles on and off.
Subtitles On
Note
• When a programme is recorded with this function on, subtitles
are also recorded.

Reconfiguring the DTV channel settings

This section describes how to reconfigure the DTV channel settings
after setting up DTV channels using Auto Installation (page 27). You
can select "DTV Setup" only when watching DTV channels.
Reselecting a country
1 Press HOME MENU.
2 Select "Setup" (/ then ENTER).
3 Select "DTV Setup" (/ then ENTER).
4 Select "Installation" (/ then ENTER).
• The password entry screen appears. Enter your four-digit
password using buttons 0 to 9.
5 Select "Country" (/).
6 Select a country (/).
Installation
Aerial Power
Country
Add New Channels
Replace Existing Channels
Signal Check
Restore System Defaults
Note
• The password entry screen does not appear if you have disabled
the password function. For details, see Using a password on
page 56.
• You can select "DTV Setup" only when watching DTV channels.
40
En
Replacing the existing channels
The following procedure discards the current DTV channel setups
and searches for receivable channels to redo the channel setups.
1
2
• The system first erases all channel information and then starts
• To quit a channel search in progress, press HOME MENU.
• To complete "Replace Existing Channels", there must be more
• The password entry screen does not appear if you have disabled
• You can select "DTV Setup" only when watching DTV channels.
Adding new channels
Off
Use the following procedure to search and register new channels
Germany
with the current DTV channel setups saved.
1
2
• Channel search automatically starts. If any new channel is
• To quit a channel search in progress, press HOME MENU.
• The password entry screen does not appear if you have disabled
• You can select "DTV Setup" only when watching DTV channels.
Repeat steps 1 to 4 provided for Reselecting a country.
Select "Replace Existing Channels" (/ then ENTER).
channel search.
Replace Existing Channels
Search Information
Existing Channels 04
Channels Found 20
Progress 30%
Note
than one hour at least left to the next preset recording or preset
Auto Update time.
the password function. For details, see Using a password on
page 56.
Repeat steps 1 to 4 provided for Reselecting a country.
Select "Add New Channels" (/ then ENTER).
found, it is automatically registered on the plasma television.
Add New Channels
Search Information
Existing Channels 04
Channels Found 20
Progress 30%
Note
the password function. For details, see Using a password on
page 56.
Found Channels
001
************
002
************
003
******
004
************
Found Channels
001
************
002
************
003
******
004
************