Bosch 1 270 020 900 Notice Originale page 29

OBJ_BUCH-1407-002.book Page 5 Wednesday, September 28, 2011 9:48 AM
Error Code Indication
The components of the eBike drive are continu-
ously and automatically monitored. When an er-
ror is detected, the respective error code is in-
dicated in display e.
Depending on the type of error, the drive is au-
tomatically shut off if required. Continued travel
without assistance from the drive is possible at
any time. However, have the eBike checked be-
fore attempting new trips.
Code Cause
001 Internal error of the drive
HMI
002 One or more buttons of the
drive HMI are blocked.
003 Connection problem of the
drive HMI
100 Internal error of the drive unit Have the drive unit checked
101 Connection problem of the
drive unit
102 Error of the speed sensor
103* Connection problem of the
lighting system
104 Connection problem of the
drive HMI
105 Temperature of the drive unit
too high (above 40 °C)
200 Internal electronics error of
the battery
201 Temperature of the battery
too high (above 40 °C)
202 Temperature of the battery
too low (below –10 °C)
203 Connection problem of bat-
tery
204 Incorrect battery polarity
* only for eBike lighting via battery (country-specific)
Bosch eBike Systems
Have all inspections and repairs carried out
only by an authorised bicycle dealer. When
an error is still displayed despite corrective
measures, please also refer to an authorised
bicycle dealer.
Corrective Measure
Have the drive HMI checked
Check if any buttons are blocked, e.g. from dirt or de-
bris. Clean the buttons, if required.
Have connections and contacts checked
Have connections and contacts checked
Have the speed sensor checked
Have connections and contacts checked
Have connections and contacts checked
Allow the drive unit to cool down. Continued travel with-
out assistance from the eBike drive is possible and
speeds up the cooling of the drive unit.
Have the battery checked
Allow the battery to cool down. Continued travel without
assistance from the eBike drive is possible and speeds
up the cooling of the battery.
Allow the battery to warm up slowly in a warm location.
Have connections and contacts checked
Charge the battery with the original Bosch charger as de-
scribed in the operating instructions.
English–5
0 276 001 XXX | (28.9.11)