EUROM 248104 Manuel D'utilisation page 25

To change the brush, loosen the nut once more and remove the worn brush. Before
placing a new brush, check that the compression bush is in the holder!
User instructions
Before use
 Check that the steering handle, the wheel, the brush and the closure on the
telescopic tube are secure and adjusted correctly.
 Check that the socket you are using provides the correct voltage (see
specification plate on weed brush).
 Connect the weed brush to a suitable extension cable and hook the cable behind
the clamp (see fig. A).
 Hold the device with both hands (one hand on each handle) and check that the
underside of the device is flat and horizontal.
Operating
 If all checks are ok, you can insert the plug into the socket.
 Now press the unlocking device (2), press the ON/OFF switch (1) and keep it
depressed.
 Release the ON/OFF switch in order to switch the device off. The device will lock
automatically.
Use
Move the device over the surface area to be treated at a constant speed. For the
best results, you are advised to test the device on a small area first. Check to
ensure the tiles are not damaged.
Only use the device for dry weeds.
Keep the device out of the vicinity of hard objects and plants.
Brush the long edges first and then the short ones.
Do not use the brush in the same spot for too long. The brush will then push into
the joints and will remove the sand/soil.
Regular brushing helps prevent stubborn weeds taking hold.
Cleaning and Maintenance
Always remove the plug from the socket if you are carrying out
maintenance!
The weed brush needs special cleaning.
 Regularly clean the ventilation openings with a soft cloth.
 Regularly remove dirt from the cover with a soft brush.
Problems and solutions
Always pull the plug out of the socket if you establish or intend to solve a
problem!
25