EUROM 248104 Manuel D'utilisation page 24

 Determine your desired length of the weed brush by sliding the telescopic tube
in and out. When you have found the right length, slide the locking ring over the
compression fitting again and tighten both sections again firmly.
 You can adjust the length by loosening the locking ring, sliding the telescopic
tube and tightening the locking ring once more.
 Check before use that the tube is properly fastened!
Assembly of the protective cover (fig. B)
 Mount the protective cover (6) on the device, as shown in
drawing B.
 Secure the protective cover with the screws (12).
 Replace the cover when it gets worn.
Wheel assembly (fig. C)
 Put the wheel axle (8) into the assembly hole (13) made
for this purpose.
 Push the axle firmly into place.
Brush assembly (fig. D)
 The hard brush supplied is suitable for
regular and stubborn weeds.
 Two brushes are supplied as standard.
 A worn brush must be replaced immediately.
Before securing or changing a brush, always pull the plug out of the
Wear protective gloves when assembling the brush.
The holder (16) to which the motor shaft is attached sticks out of the device. Check
that the copper coloured compression bush is in the holder (or insert it). The
hexagonal nut is now placed over the holder and the collar. Now insert the brush
shaft through the back of the nut as far as possible into the collar. Finally, firmly
tighten the nut (17) using both spanners (14 & 15).
socket!
24