Starting And Ending Configuration Mode; Menu Level 1: Set Temperature - Dometic COOLAIR RT780 Instructions De Montage

CoolAir RT780
8.1

Starting and ending configuration mode

The adjustable parameters can be changed in configuration mode:
➤ When using the
pressed until the compressor LED flashes.
✓ You are now in configuration mode.
✓ The display version (e. g. "3.1S") appears in the display for 2 seconds.
✓ The first digit of the display shows the menu level and the second and third
digits show the parameters which can be set, e.g.
set target value of 17 °C.
I
NOTE
If you make no entry on the control panel for 60 seconds, the unit quits
configuration mode and shuts down.
➤ Press the
8.2

Menu level 1: Set temperature

The unit always starts with a defined value for the room temperature. This
parameter can be configured between 17 and 30 °C (62 and 86 °F).
➤ Start configuration mode (chapter "Starting and ending configuration mode"
on page 21).
✓ The first digit of the display shows the menu level and the second and third
show the parameter which can be set.
➤ Press the
➤ Use the + and – buttons to select the target value (in °C) at which the unit
should start operation.
✓ The digits in the display flash until the parameter you entered is confirmed.
➤ Press the
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 1 again and can use the + and – buttons to switch
between menu levels.
EN
button to switch on the unit, hold both buttons + and –
button to quit configuration mode.
button to change the parameters.
button to confirm your entry.
Configuration of unit software
1.17
for menu level 1 and a
21