Installing The Microphone - Pioneer AVIC-EVO1 Manuel D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
Dashboard
Rear shelf
• When installing the GPS aerial inside
the vehicle, be sure to use the metal
sheet provided with your system. If this
is not used, the reception sensitivity
will be poor.
• Do not cut the accessory metal sheet.
This would reduce the sensitivity of the
GPS aerial.
• The metal sheet contains a strong
adhesive which may leave a mark on
the surface if it is removed.
• Take care not to pull the aerial lead
when removing the GPS aerial. The lead
may become detached.
• Do not paint the GPS aerial, as this may
affect its performance.
• Some models use window glass that
does not allow signals from GPS
satellites to pass through. On such
models, install the GPS aerial on the
outside of the vehicle.
For details on the installation method
for each vehicle type, refer to the
separate installation manual and install
this product properly.
12
En
Installing the
microphone
• Install the microphone in a place where
its direction and distance from the
driver make it easiest to pick up the
driver's voice.
• Be sure to turn off (ACC OFF) the
product before connecting the
microphone.
• Depending on the vehicle model, the
microphone cable length may be too
short when you mount the microphone
on the sun visor. In such cases, install
the microphone on the steering
column.
• Install the microphone on the sun visor
when it is in the up position. It cannot
recognise the driver's voice if the sun
visor is in the down position.
For details on the installation method
for each vehicle type, refer to the
separate installation manual and install
this product properly.

Publicité

Table des Matières
loading

Table des Matières