Turning Off And Releasing From The Wheelchair; Closing / Opening For Transportation; Cleaning - Klaxon KLICK Série Mode D'emploi

4. Brake lever
Once the device has been installed, the display has been turned on and a speed has been selected, use the accelerator control to make the device
start to move (Figure 31.1). To stop the device, use the brake lever. The KLICK brake is equipped with an additional safety device which deactivates
the motor when the lever is operated (Figure 31.2).
At each restart pay maximum attention, before accelerating, to check if forward or reverse operation is currently selected,
DANGER
especially when close to obstacles, drop-offs and any other kind of danger.
If obstacles, drop-offs and dangers are too close to be safe, turn off the KLICK device and manually move the wheelchair to
DANGER
a safe place.
After inserting the battery in its housing and locked by turning the key, remove it and put it in a safe place. It is absolutely
CAUTION
forbidden to use the KLICK device with the key insert in the security block.

16.4 TURNING OFF AND RELEASING FROM THE WHEELCHAIR

To perform the operation properly, carefully follow the following instructions.
Stop the wheelchair on a flat surface.
Apply the brake on the wheelchair.
Turn off the display by pressing and holding the "
Push the handlebar forward with one hand grasping it in the middle and simultaneously press the release button on the CONNECTOR with
the other hand. This frees the lower pin of the KLICK coupling (Figure 34).
Reduce forward pressure on the handlebar while holding the release button on the CONNECTOR, thus lowering the wheelchair so that its
front wheels make contact with the pavement (Figure 35).
At this point the upper pin will already be pulled out the front hook of the CONNECTOR; release the wheelchair's brakes and push yourself
back to move away from the KLICK device (which in the meantime will remain upright thanks to its KICKSTAND - Figure 36).
Remove the CONNECTOR, pulling the lever located on its bottom (Figure 20).
During the KLICK release operation, pay attention to not endanger the top parts of your body (fingers, hands, arms) as they
DANGER could be affected by the sudden movement of the handlebar (or other parts of the device) if it is released too quickly. To avoid
this danger, after pressing the release button, gently release the handlebar by lowering the wheelchair gradually.

16.5 CLOSING / OPENING FOR TRANSPORTATION

To perform the operation properly, carefully follow the following instructions.
Make sure that the device is off and the safety button on the battery disabled (Figure 46).
Loosen the safety rings on the handlebar, turning them counter-clockwise with respect to the "ON" arrow (Figure 64).
Move the safety rings outwards, unlocking the handlebar and making it collapse downward (Figures 65 and 66).
Push up the safety button on the release lever and pull the latter outwards until it is completely disengaged (Figures 67 and 68).
Fold the upper part of the handlebar to the side, rotating it 180 degrees; in closed position, it shall lie alongside the lower part of the steering
tube, beside the battery holder (Figure 69).
To open the Klick device, perform the above operations in reverse order.
During the closing phase of KLICK MS / CS, pay the utmost attention not to damage the (electric and mechanic) wires that
CAUTION run inside the frame of the device. Perform the opening and closing operations slowly, making sure that the wires do not
interfere with moving parts, as these could pinch or break.
If some elements of the electric or mechanic system get damaged during the opening and closing of the KLICK MS / CS
DANGER
devices, do NOT absolutely use the devices and take it immediately to an authorized KLAXON service centre.
Once the KLICK MS / CS has been opened, before using it check that all joints are properly closed and that safety buttons (side
DANGER
lever and handlebar rings) are fully fastened. Only use the device when it is completely open (Figure 70).

17. CLEANING

Regularly cleaning the entire device makes it last longer and work better.
We recommend to:
Before cleaning, switch the device off and disconnect the battery charger.
Do not use abrasive cleaning agents, detergents and high pressure cleaners.
Clean the device with a soft, damp cloth.
Thoroughly dry the device after use in the rain.
If the device is soiled, soften the dirt and remove it as soon as possible; then dry the device carefully.
Clean all the outside of the device at least once a month and after each ride on muddy terrain.
KLAXON Mobility GmbH - ENG
M
" button for 5 seconds.
KLICK electric series Manual (ENG) - rev.6.3 of 10.01.2020
21