Markings - Klaxon KLICK Série Mode D'emploi

Do not use KLICK devices (ES, ET, PS, PT, RS, RT, FS versions) to go up or down steps higher than 5 cm.
Do not use KLICK devices (MS, CS versions) to go up or down steps higher than 2.5 cm.
Do not use KLICK devices on slopes greater than 10%.
When driving downhill, do not exceed two-thirds of the maximum speed; avoid sudden braking or accelerations on slopes.
Never go over obstacles when driving uphill or downhill.
Do not go up or down staircases.
Do not attempt to go over obstacles diagonally: make sure that the rear wheels always go over the obstacle together. Never
stop halfway. Do not attempt to go over obstacles over 5 cm high (ES, ET, PS, PT, RS, RT, FS versions). Do not attempt to go
over obstacles over 2.5 cm high (MS, CS versions).
When the vehicle is in motion, avoid moving the centre of gravity or abruptly moving your body.
It is advisable to drive through narrow passages at minimum speed and with utmost caution.
When using KLICK devices, the risk of tipping over during cornering increases: reduce speed before turning. Accelerate again
only after completing the curve.
When using KLICK devices, do not make U-turns on slopes greater than 5% and at a speed higher than level 1.
It can be difficult to manoeuvre in front of a lift or at the entrance of a building since the wheelchair's turning radius increases
when coupled with a KLICK device; this could conflict with the standards of the buildings or the actual size of the entrances.
When entering a building and/or an elevator, always take into account the turning radius of your wheelchair equipped with
the KLICK device. Avoid driving into situations from which you would not be capable of exiting because you would be unable
to turn your wheelchair.
Absolutely never use the Klick device along tramway, rail and light railway tracks. Pay the utmost attention at level crossings,
keeping the Klick's and wheelchair wheels at due distance. Failure to comply with this precaution could cause serious
damages to the device and the user. The same precautions apply to water drains, manholes and all kinds of hollows along
the way.
When using the KLICK MS and CS devices, pay the utmost attention to safeguard the braking system; the user must
especially avoid (side and frontal) obstacles that can damage the disc.

8. MARKINGS

The device is uniquely identified by its serial number (SN), shown on the plate of the device, attached to the motor unit near the battery. The
meaning of the symbols shown in the plate are as follows:
Symbol Description
Manufacturer
Reference number
Serial number
8
KLAXON Mobility GmbH - ENG
KLICK electric series Manual (ENG) - rev.6.3 of 10.01.2020