Servicing; Periodical Maintenance; Malfunctions; Fly Slim Battery (2.5 Ah) - Klaxon KLICK Série Mode D'emploi

Be careful not to wet the electrical parts (battery, display, motor).
Do not wash the parts under running water
Dry the parts immediately after washing, using a soft cloth.
If the electrical parts get wet, let them dry and do not use the device until they are completely dry.

18. SERVICING

KLICK devices must be serviced regularly, to ensure safe, reliable and efficient operation.
KLAXON is not responsible for any damage caused by non-maintenance or by insufficient maintenance, and in said cases the warranty may lapse.
Unscheduled maintenance can be carried out only by technicians authorised by KLAXON's Technical Support Service.

18.1 PERIODICAL MAINTENANCE

We recommend the following regular maintenance:
At least once a month, check the tyre inflation pressure; a flat tyre affects the vehicle's smooth ride, its safety and its power consumption.
At least once a month, check wear of the tyres. To replace an inner tube or a tyre, contact an authorised KLAXON technician.
At least once every two months, check the tightness of all screws and fasteners.
At least once a month, check the tightness of the fixing nuts of the wheels' pins with a torque wrench calibration at 30Nm (Electric Standard,
Electric Tetra, Power Standard, Power Tetra, Mini Standard, Carbon Standard versions).
At least once a month, check the tightness of the fixing nuts of the wheels' pins with a torque wrench calibration at 50Nm (Race Standard,
Race Tetra, Monster Standard versions).
Before each use, check proper operation of the accelerator and brakes: any replacement of parts subject to wear (brake pads, discs, brake
system in general) should be carried out only by authorised KLAXON technicians. The vehicle should also be checked whenever you feel the
braking power has decreased.
Check the condition of the battery, before each use. To replace the battery, and any other electrical component, contact only authorised KLAXON
technicians.
Have a KLAXON qualified technician overhaul the entire device at least once a year, and/or whenever a malfunction occurs.

18.2 MALFUNCTIONS

If you encounter a malfunction during use of the KLICK device, contact KLAXON or of its authorised resellers.
Malfunction found
The device does not turn on
It vibrates excessively during use
The display lights up but the device
does not move
You have problems coupling the
traction unit to the connector
You have problems attaching the
connector
You have problems attaching the
connector
Wheelchair front wheels touch the
ground
KLICK is noisy when in use

18.3 FLY SLIM BATTERY (2.5 AH)

The FLY SLIM battery (36 V and 2.5 Ah) is cylindrical and secured to the connection with an elastic rubber strap (Figure 44).
22
KLAXON Mobility GmbH - ENG
Possible cause
The battery is empty
The battery is positioned improperly
General problems
Loose screws
Disconnected plug
The connector is not adjusted properly
There is dirt inside the coupling seat in the
crossbeam
The interlocking balls do not retract when
pulling the lever
The Klick coupling is mounted too low
The fender touches the wheel while
moving
The brake pads touch the disc when
reversing
KLICK electric series Manual (ENG) - rev.6.3 of 10.01.2020
Corrective action
Recharge the battery
Check the position of the battery by removing it and
inserting it again, making sure that the electrodes are
inserted in the appropriate spaces.
Contact an authorised KLAXON service centre
Contact an authorised KLAXON service centre
Contact an authorised KLAXON service centre
Contact an authorised KLAXON service centre
Clean the surfaces of the seat in the crossbeam and of
the mounting system in the connector
Contact an authorised KLAXON service centre
Contact an authorised KLAXON service centre
Make sure your feet are in a position that does not
interfere with the fender of the device
Reposition the fender, putting it back into place.
Contact an authorised KLAXON service centre