WANDERS Domus Mode D'emploi Et Instructions D'installation page 22

Make your choice from the installation possibilities
shown above. Place the first meter of the concentric
pipe on the counterpart on the appliance. You will know
that you placed it properly if you can see the blue rubber
seal ring when looking from above. Keep a distance of at
least 5 cm between the inner side of the concentric pipe
and the wall or the ceiling.
Pay special attention to proper installing when, due to
circumstances, a part of the double-walled pipe system
must be built in.
Exterior wall duct
• Always allow one metre vertical before passing
through the outer wall.
• Determine the location of the gas unit and the exterior
wall duct.
• Make an opening of Ø 55 mm for the wall duct.
• Connect the wall duct with a curve to the mouth of the
appliance. Push them firmly together and place the
clip bindings. The blue rubber ring ensures sufficient
sealing of the discharge system of the waste gas.
• If the appliance is placed more than  metre from
the wall, place the vertical one-metre pipe first on
the appliance, then place the curved part, then the
exterior wall duct, and then make them gastight.
Outflow on top of the roof
You can place the outflow anywhere on the roof, if
necessary with a bend to the ridge of the roof. The roof
duct is supplied with a universally adjustable roof tile for
a tilted roof, or with an adhesive plate for a flat roof.
• Determine the location of the gas unit and the outflow
to the roof.
• Make an opening of Ø 55 mm for the roof duct.
• Connect the pipes vertically to the mouth of the
appliance. Push them firmly together and place the
clip bindings.
• Determine the length of the pipes needed and make
sure that the transfer tile or the universal roof tile is
well fitted to the roof.
• Saw the outer pipe off to measure, and connect the
concentric pipes to the roof duct.

First install the pipe system, and then place the gas
unit
You may also fit the concentric pipe system before
placing the gas unit, but then you must the connection
to the gas unit with a pipe that can be shifted.
Completing the installation
The concentric system is now fitted and the hearth is
installed. To complete the installation, the following
must be carried out:
Opening the door
The gas fireplace must be ignited only when the door
is closed. The door is locked for safety reasons. You can
open the door by turning the screw clockwise. Once the
door is open you can place the ceramic lumber set. The
Domus or Luna Petite can be fired by natural gas only.
Placing the ceramic lumber set
• Fill the bottom of the burner with the supplied
granules. Never use more granules than the supplied
quantity.
• Make sure that you place the ceramic logs exactly
as shown in the illustrations and in the especially
designed recesses of lower logs. Always place the logs
with the sharp or round edges pointing downwards to
avoid covering the flames.
• PLEASE NOTE: Do not touch the glass with your
fingers when closing the door of the gas unit. Finger
marks will burn in the glass.
• Firmly close the door before lighting the hearth.
Step 
Step