WANDERS Domus Mode D'emploi Et Instructions D'installation page 16

Installation
It is common practice for the dealer where you
purchased your gas unit to take also care of installing
it and connecting it to the mains. If this is not the case,
please ensure that the installation is done by a certified
installer. Connecting gas devices by unqualified persons
is prohibited, in which case we cannot give any guarantee
that your gas hearth is functioning properly.
Ready for use
After connecting your Wanders gas unit to the mains and
making the necessary adjustments, the hearth is ready
for use. The pilot flame must be ignited manually.
Gas governor (A)
Lighting the pilot flame manually
Open the flap at the bottom of the hearth. Check whether
the gas tap is turned on. You will see the control buttons
of the hearth in the middle behind the flap.
. Turn the ignition knob (A) clockwise until it stops,
then press the knob and wait a few seconds.
. While keeping the knob pressed, turn the knob to
the left until you hear a click.
. Look through the glass pane to see whether the pilot
flame at the left of the hearth is burning. If the pilot
flame is not ignited, repeat steps  and .
4. If the pilot flame is burning, keep the ignition knob
pressed for some time. When you release the knob
after 0 seconds, the pilot flame must stay alight. If
it doesn't, wait for 5 minutes before trying to light
the pilot flame again.
5. If the pilot flame stays alight, turn the knob anti-
clockwise till the symbol of the large flame. Now
you can close the flap and regulate the height of the
flames with the remote handset.
Child-proof safety lock
If you turn the ignition knob to the symbol of the
small flame, the remote control is put out of action
while the pilot flame will stay alight.
6
Arranging the height of the flames
Point the remote control handset towards the gas unit.
The hearth will burn higher when pressing the ▲ button.
The hearth will burn slower when pressing the ▼ button.
When you keep pressing the ▼ the hearth will switch to
the pilot flame position. You can also put the hearth on
the pilot flame position manually by turning the ignition
knob (A) clockwise until the minimum is reached.
When you press both buttons, you will see the 'transmit'
signal top left on the display. The hearth has reached its
highest or lowest position when the LED of the receiver
starts blinking.
Switching off the pilot flame
The pilot flame is switched off manually. Open the
flap, gently press the ignition knob (A) and then turn it
clockwise.
Lighting the hearth for the first time
When you light your gas unit for the first time, the hearth
must 'anneal'. The unit has a heat resistant lacquer which
must still burn in. Though this may give an unpleasant
smell, it is otherwise harmless. It is advisable to turn onto
high for about three hours while airing the room well.
Discolouration of walls, ceilings and grates
After lighting your heath the walls, ceilings and grates
may show some discolouration. This is caused by the
dust particles that burn in the convection cover. This
is a natural process for which WANDERS can not
be held responsible. To minimize the discolouring
we refer to the advice given for atmospheric hearths.
Your installer can give you more information about
this.
Some deposit may form on the ceramic glass of the door
of the hearth. You can easily remove this deposit with
a damp cloth and if necessary some cleansing agent
for ceramic rings when the glass has cooled down. You
can open the door of the hearth by turning the screw
clockwise at the bottom. You can use a coin for this.
Opening the door