Preview Grab-N-Go; Grab-N-Go Case - KENMORE ELITE 795.7407 Guide D'utilisation Et D'entretien

PREVIEW GRAB-N-GO

The PreView Grab-N-Go
compartment allows for easy access
to commonly used food items.
PREVIEW GRAB-N-GO
COMPARTMENT
To access the PreView Grab-N-
Go compartment, lightly press the
button on the right refrigerator door
handle to open the door.
PREVIEW FUNCTION
The PreView function on the Grab-
N-Go lets you see if you're running
low on frequently used items like
beverages and snacks, without
opening the refrigerator door.
1. Knock twice on the glass to turn
the LED light inside the Grab-N-
Go on or off.
2. The LED light turns off
automatically after ten seconds.
• The PreView Grab-N-Go function
is disabled when the right
refrigerator door is open, for two
seconds after closing the door,
and when the ice dispenser is in use.
• Knock near the center of the glass. Knocking near the
edges of the glass may not activate the PreView Grab-
N-Go function properly.
• Knock hard enough that the knocking sound is audible.
• The PreView Grab-N-Go function may activate if a
loud noise occurs near the refrigerator.
USING YOUR REFRIGERATOR

GRAB-N-GO CASE

To open the Grab-N-Go case, slightly push the marked
area to pop it open. The Grab-N-Go Case is removable
for easy cleaning and adjustment.
1. To remove the Grab-N-Go case, lift up and pull out.
2. To replace the Grab-N-Go case, line the tabs on
the Grab-N-Go case with the slots on the door and
push down until the case snaps into place.
< Open > < Removing >
GRAB-N-GO LOWER SHELF
The Grab-N-Go lower shelf is removable for easy
cleaning.
1. To remove the lower shelf, lift the shelf retainer up
and out.
2. Remove the two screws from the shelf and pull it
straight out.
3. Reverse procedure to replace.
1
27
< Assembling >
3
2