Dmx-512 Connection / Connection Between Fixtures - Futurelight DJ-HEAD 250 SPOT Mode D'emploi

Pro-head-spot
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

For overhead use (mounting height >100 cm), always install a safety-rope that can hold at least 12 times the
weight of the fixture. You must only use safety-ropes with quick links with screw cap. Pull the safety-rope
through the hole on the bottom of the base and over the trussing system etc. Insert the end in the quick link
and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
Screw one clamp each via a M12 screw and nut onto the mounting holder.
Insert the quick-lock fasteners of the first mounting holder into the respective holes on the bottom of the
device. Tighten the quick-lock fasteners fully clockwise. Install the second mounting holder.

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
29/68
00025523.DOC, Version 1.2

Publicité

Table des Matières
loading

Table des Matières