Zanussi ZRG14801WA Notice D'utilisation page 22

Problem
Water flows on the ground.
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.
The temperature in the re-
frigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
22
Possible cause
The melting water outlet does not
flow in the evaporative tray above
the compressor.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in the
appliance.
Products are too near to each other. Store products so that there is cold
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not set
correctly.
Attach the melting water outlet to the
evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same time.
Make sure that there is cold air circu-
lation in the appliance.
air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
Remove the screw
from the lamp cover.
Remove the lamp
cover (refer to the il-
lustration).
Replace the used
lamp with a new lamp
of the same power
and specifically de-
signed for household
appliances (the maxi-
mum power is shown
on the lamp cover).
Install the lamp cover.
Tighten the screw to
the lamp cover.
Connect the plug to
the mains socket.
Open the door. Make
sure that the light
comes on.
Solution
www.zanussi.com