Zanussi ZRG16601WA Notice D'utilisation page 19

10 mm to allow the door to open enough so
that the shelves can be removed.
Warning!
min.
100 mm
15 mm 15 mm
1. Remove the plug
from the power socket.
2. Tilt back the appli-
ance carefully so that
the compressor can-
not touch the floor.
3. Unscrew the left
feet.
4. Unscrew the screws
of the door bottom
hinge.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cabi-
net. In that case, wait for the natural fitting of the
gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service
specialist will carry out the reversibility of the
doors at your cost.
www.zanussi.com
2
1
5. Take off the appli-
ance door by pulling it
slightly downwards.
6. Unscrew the top
door hinge pin of the
appliance then screw
it back on the other
side.
7. Fit the appliance
door on the upper
door hinge pin.
It must be possible to disconnect the appliance
from the mains power supply; the plug must
therefore be easily accessible after installation.
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
8. Remove the lower
hinge. Put over the pin
in the direction of the
arrow.
9. Unscrew and install
the screw on the op-
posite side.
10. Install the lower
hinge on the opposite
side leaving the posi-
tion of the door un-
changed.
11. Screw in the one
screw in the place set
free on the other side
as well as the right
feet.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
The appliance must be earthed. The power sup-
ply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is
not earthed, connect the appliance to a sepa-
rate earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
12. Remove and install
the handle (if foreseen)
on the opposite side.
13. Reposition, level
the appliance, wait for
at least four hours and
then connect it to the
power socket.
19