Contents
The Transmitter
10
11
12
ST
TH
BIND
N
R
N
ST-L
ST-R
TH-F
15
16
6
5
ST. TRIM
ON
OFF
TH. TRIM
4
7
9
Losi 1/10 22 2WD ELEctric Buggy rtr • iNstructioN maNuaL
13
14
AUX
AUX
R
N
R
2P 3P LIN
TH-B
AUX-H
AUX-L
3
8
ST. RATE
Installing Batteries
1. Push in the battery cover a small
1
2
2. Install 4 AA batteries, taking care
3. Carefully re-install the battery cover
1. Steering Wheel: Controls direction (left/right) of the model.
2. Throttle Trigger: Controls speed and direction
(forward/reverse) of the model.
3. Antenna: Transmits signal to the model.
4. On/Off Switch: Turns the power on/off for the transmitter.
5. Indicator Lights: Green (right) light indicates adequate
battery power. Red (left) indicates signal strength.
6. ST. Trim: Adjusts the "hands off" direction of the model.
7. TH. Trim: Adjusts the motor speed to stop at neutral.
8. Steering Rate: Adjusts amount front wheels move when
the steering wheel is turned left and right.
9. Bottom Cover: Covers and holds the batteries that power
the transmitter.
10. BIND Button
11. ST. REV: Reverses the function of the steering when the
wheel is turned left or right.
12. TH. REV: Reverses the function of the speed control when
pulled back or pushed forward.
13. TH-F: Forward Endpoint. Adjusts the amount of full throttle.
14. TH-B: Brake Endpoint. Adjusts the amount of full brake.
15. ST-L: Steering Left Endpoint. Adjusts the amount of left
steering travel.
16. ST-R: Steering Right Endpoint. Adjusts the amount of right
steering travel.
amount to release the retaining tab,
then remove the cover.
to align battery polarity to the diagram
in the transmitter's battery case.
by aligning the tabs with the slots
on the transmitter.
CAUTION: Do not remove transmitter batteries while the model is powered
on or while operating, as a loss of model control, damage or injury can result.
ST. TRIM
ST. RATE
TH. TRIM
EN
3