Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.
Put the appliance in the opening of the worktop.
6.
Connect the appliance to the mains supply.
After connecting the display lights up for a short time. The appliance is ready for use.
INSTALLING THE FINISHING
1.
Remove the protective film (B) from the finishing (A).
2.
Put the finishing around the appliance. Make sure that there is a distance of 2 mm between the appliance and
the seal.
INSTALLING THE DECORATION STRIPS
The packaging includes two stainless steel decoration strips.
Note:
The decoration strips cannot be removed once attached to the induction hob.
1.
Attach the decoration strips to the sides of the induction hob.
SETTING THE POWER MANAGEMENT
Use the power management mode to set the total maximum power of the appliance.
Note:
As a default, the appliance is set to 7.4 kW.
Note:
Setting the power management must be done within 2 minutes after connecting the appliance.
1.
Connect the appliance.
2.
Make sure that all cooking zones are off.
3.
Hold the two buttons of the bottom cooking zones simultaneously for 3 seconds.
You will hear a sound signal and the display timer shows the current value.
4.
Change the value to the correct setting. Use the up and down buttons.
Note:
To stop setting the power management, do not touch a button for 60 seconds.
5.
Hold the two buttons of the bottom cooking zones simultaneously for 3 seconds to confirm the setting.
You will hear a sound signal when the new setting is confirmed.
REMOVING THE APPLIANCE
1.
Disconnect the appliance from the mains supply.
2.
Push the appliance up to remove it.
5

Operation

The appliance has electronic sensors that activate when you touch the buttons on the control panel. The appliance
makes a sound when a control is touched.
Caution:
Only use pans that are suitable for an induction appliance. Refer to section
30
EN
(Figure 13)
'Requirements for pans'
.

Publicité

Table des Matières
loading

Table des Matières