Operation - Inventum IKI9040 Manuel D'utilisation

7. Touch the memory button to confirm the setting.
All displays show -.
8. Touch the on/off button to finish the configuration.
REMOVING THE APPLIANCE
1. Disconnect the appliance from the mains supply.
2. Push the appliance up to remove it.
5

Operation

The appliance has electronic sensors that activate when you touch the buttons on the control panel. The appliance
makes a sound when a control is touched.
Caution:
Only use pans that are suitable for an induction appliance. Refer to section
PREPARING FOR OPERATION
1. Clean the appliance before operation. Use a damp cloth.
STARTING THE APPLIANCE
1. Touch the on/off button to start the appliance. The operation indicator shows 0.
Note:
If you do not select a cooking zone within 20 seconds, the appliance automatically switches off.
USING A COOKING ZONE
Selecting a cooking zone
1. Put a pan on the cooking zone.
2. Touch the selection/timer button of the cooking zone.
3. Use the up button to increase the power level. The operation indicator shows the set power level.
4. Use the down button to decrease the power level. The operation indicator shows the set power level.
Stopping a cooking zone
1. Stopping the cooking zone can be done with one of these procedures:
a. Use the down button to decrease the power level to 0.
b. Touch the selection/timer button and the down button simultaneously.
Note:
The operation indicator shows H to indicate the cooking zone is still hot.
USING THE BOOSTER MODE
The booster mode provides extra power to a cooking zone.
Note:
The booster mode does not work when you are already using the bridge mode.
Note:
If you select another cooking zone during the booster mode, the power is more than the maximum
available power of the appliance. The booster mode stops automatically.
32 •
EN
'Requirements for pans'
.