Before First Use; Cleaning & Maintenance; Operation - Inventum KP 411 Mode D'emploi

2 | before first use
Before you use the appliance for the first time, please do
as follows: carefully unpack the appliance and remove
all the packaging material. Keep the material (plastic
bags and cardboard) out of reach of children. check the
appliance after unpacking for any damage, possible from
transportation. place the appliance on a stable and heat
resistant surface. clean the appliance with a damp cloth.
the hotplate(s) has (have) a protective layer which should
be removed before the first use. Switch the hot plate
on for about 5 to 6 minutes on the maximum position.
there can be a slight development of smoke from the
protective layer which is now burning of. after removing
the protective layer you can now switch the hot plate of
or begin using it.

3 | oPerAtion

the thermostat button is a turning knob which is
completely retractable. press the center of the button to
let it pop out or retract. the thermostat button can be
turned left and right and be retracted in every position.
the thermostat button is adjustable: On is low and max
is high.
make sure the thermostat button is set to position «Off»
before you switch on the appliance. plug the appliance
into a socket.
for heating the hot plate(s) turn the knob clockwise.
the red control light will burn. position «Off» is Off
and position «max» is the highest position. It takes
about 10 minutes before the hot plate has reached the
maximum temperature (on the maximum position of the
thermostat knob). If the temperature is reached which
conforms to the set position, the control light will go out.
after a temperature drop, giving of heat to the pan, the
thermostat and the control light will switch on.
Attention: tHE appLIancE can gEt HOt durIng uSE.
tHErEfOrE aLWayS pLacE tHE appLIancE On a HEat
rESIStant SurfacE and nEvEr On a pLaStIc taBLE Or
pLaStIc taBLE cLOtH.
use only pots with a bottom which has the same cross­cut
as the hot plate. a smaller cross­cut will lead to energy
loss. model Kp411 has a cast iron plate with a cross­cut of
174 mm. model Kp421 has a cast iron plate with a cross­
cut of 174 mm and a cast iron plate with a cross­cut of
143 mm.
do not touch the hot plate when in use. Be careful: the
hot plates need time to cool down after switching the
appliance of.
4 | cLeAning & mAintenAnce
Let the appliance cool off and always unplug the
appliance before cleaning. Wipe the outside of the
appliance with a damp cloth and dry the kettle
afterwards. never use any abrasives! Be aware of the
fact that the appliance needs time to cool down after
switching of. never immerse the appliance in water or
others liquids.
11