Before First Use; Operation Of The Appliance; Boost Function - Inventum IKI6032 Mode D'emploi

3

before first use

Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the packaging
material. Keep the material (plastic bags and cardboard) out of reach of children. Check the appliance after unpacking for any
damage, possible from transportation. Clean the glass with a damp cloth. Check that the voltage in your home corresponds with
the voltage printed on the bottom of the appliance and plug it in a socket. Follow the installation instructions in chapter 7 for
installing the hob.
4

operation of the appliance

Use only suitable cookware on the induction hob .
After the mains voltage is applied all displays can light up for a moment. After that, the hob is in stand-by mode and is ready for
use. The stand-by light stays lit when the hob is turned off.
The hob is controlled with electronic sensors which are operated by touching the related keys. Each sensor activation is followed
by a sound signal.
SWITCHING THE APPLIANCE ON
Switch the hob on by touching the ON/OFF key for a few seconds. The displays of the cooking zones all show [0.] and the dots
blink. If there is no cooking zone selected within 20 seconds, the hob will automatically shut off.
SWITCHING THE APPLIANCE OFF
Switch the hob off at any time by touching the ON/OFF key for a few seconds.
The ON/OFF key always has priority in the switch off function.
SWITCHING ON A COOKING ZONE
Press on the key of the cooking zone you wish to use. There is a static dot indication on the selected cooking zone display and the
dots on the other displays turn off.
Place the pan on the cooking zone. Select the heat setting by using the increase heat setting key + or the decrease heat setting key
-.
To get food quickly to the boil, select the desired heat setting and touch the P key to activate the Boost function.

BOOST FUNCTION

The Boost function gives extra power and can be activated for each cooking zone. A cooking zone must be selected, the heat
setting set on the desired setting and the
the display of the selected cooking zone. P flashes in the display as long as the boost function is activated.
When using the Boost function the maximum available power will be divided between two cooking zones which work as a pair.
It is possible that the maximum available power for these two cooking zones together is exceeded. In that case the power of the
second cooking zone will be decreased automatically. The necessary power reduction is shown by blinking of the corresponding
cooking zone display. The display will blink for 3 seconds and during that time further adaptations of the settings are allowed
before the power is automatically reduced.
The duration of the Boost function depends on the selected heat setting of the corresponding cooking zone.
Setting + Boost Boost function automatically shuts off after
Setting 1 + P
Setting 2 + P
Setting 3 + P
Setting 4 + P
Setting 5 + P
22
• English
key (Boost) must be pressed. The Boost function is activated when a P appears in
1 minute
2 minutes
3 minutes
4 minutes
5 minutes
Setting + Boost Boost function automatically shut off after
Setting 6 + P
Setting 7 + P
Setting 8 + P
Setting 9 + P
-
6 minutes
7 minutes
8 minutes
8 minutes
-