Starting Up The Product Using A Magnet - ADEUNIS LoRaWAN 863-870 ANALOG PWR Guide Utilisateur

LoRaWAN 863-870 ANALOG PWR - Guide utilisateur / User guide version V2.0.2

5.7. Starting up the product using a magnet

Once the product has been configured and its assembly has been finalized, the product is ready to be started up.
The start-up is carried out using a magnet which you place on the upper part of the product (cf. the diagram below). The magnet must be held
in position for at least 6 seconds so as to confirm the start-up of the product. When the magnet is well detected, the green LED lights up for 1
second.
Once the LoRaWAN 863-870 ANALOG PWR unit validates its start-up, it immediately transmits status frames followed by a data frame (ac-
cording the defined periodicity).
Position of the magnet for
starting up the product
FR
EN
Page 79 of 87